FAG S604 Deep Groove Ball Bearing - 4 mm ID, 12 mm OD, 4 mm Width Impact sleeve The bell-shaped hydraulic ball joint

The bell-shaped hydraulic ball joint puller of series 128-H is used to press out the ball pins when removing ball joints and tie rod ends on tie rods

Bore / Inner Diameter Inch: 3

Adaptation to many engines possible

Attribute Value Radial Clearance C3 Closures Double sealed rubber seals RS/RS1/2RS1 Dimensions 12mm x 28mm x 8mm / Metric ID (inner diameter)/Bore 12mm OD (outer diameter) 28mm Width/Height/Thickness 8mm Size 12 x 28 x 8 mm Quantity One Bearing Dynamic Load Rating (Cr) 5

FAG S604 Deep Groove Ball Bearing - 4 mm ID, 12 mm OD, 4 mm Width Impact sleeve The bell-shaped hydraulic ball jointDeep Groove Ball Bearing FAG deep groove ball bearings are versatile, robust, and accommodate radial and axial loads in both directions. Their simple design, low friction, and high speed capability make them suitable for a wide range of industrial applications, from electric motors to gearboxes. Sealed and shielded variants protect against contamination, while open versions allow easy lubrication.